Skip to product information
RO Inline Mineralising Replacement Filter

RO Inline Mineralising Replacement Filter

HFS-MIN-RON10

Add the mineral finish after RO filtration.

Replace the inline finishing filter in your compatible reverse osmosis system. Ceramic mineral media adds mineral content after the membrane, before water reaches the drinking tap.

  • Adds calcium and magnesium mineral content.
  • Inline replacement for matching ¼″ tubing fittings.
$36.43
Taxes included.

Free shipping over $100

5 Micron PP Sediment Filter — 10″ × 2.5″ 5 Micron CTO Carbon Block Filter — 10″ × 2.5″ RO Replacement Membrane — HFS-ROM-75 RO Inline Mineralising Replacement Filter
Changing all four stages at once?

The Four-Stage Reverse Osmosis Replacement Filter Pack has this cartridge plus three more stages.

$145.00$158.43 View pack

Measure these two.

Measure the cartridge you're replacing, not its housing.

A filter cartridge with two measurements marked: A, overall length end to end including caps or connectors; B, widest outside diameter.
A Overall length — end to end, including caps or connectors
B Outer diameter — at the widest point of the body

Will it fit?

Match the inline body and connectors.

The listed filter size is 260 × 50 mm. Check overall length including fitted ends, body diameter, connection type and the marked flow direction.

Measured it and still not sure?

Send a photo of the cartridge beside a tape measure and we'll tell you which size it is.

Call 0474 189 347 or email sales@homefiltrationsystems.com.

Contact us

Nominal sizes vary a little between makers, so match the measurement rather than the label. What we can't tell you is how ours compares to a cartridge we didn't make and haven't tested, or whether a replacement affects your housing's own warranty; that one is between you and its manufacturer.

Fitting it, and what comes out

Cartridge installation and replacement guide

Follow the instructions for your existing system.

Download the replacement guide (PDF)

Need help with the change? Call 0474 189 347.

What happens, in order

  1. Isolate & release pressureShut off or bypass the supply. Release pressure.
  2. Replace the cartridgeReplace after the RO membrane. Follow the marked flow direction.
  3. Flush & checkRestore slowly. Flush as directed and check for leaks.
  4. Record the changeRecord the date. Check cartridge condition and flow regularly.

Reviews

What people who fitted it said.

Only buyers we can match to an order can leave one, so the count is lower than it would be otherwise.

FAQ

Before you order

Talk to someone

Need help choosing? Call 0474 189 347.

Where does it fit in my RO system?

It is the inline finishing stage after the RO membrane. Match the ¼″ tubing fittings and your system’s flow direction.

When should I replace it?

Plan to replace it every 6–12 months. Water quality and use can require earlier changes.

Does it replace the RO membrane?

No. Fit it after the membrane as specified by your system. It adds mineral content; it does not perform the membrane’s separation job.